Tyan S5393WG2NR Fiche technique télécharger pdf (Page 25)

http://www.tyan.com

2.8 - Attaching Drive Cables

Attaching IDE Drive Cable

Attaching the IDE drive cable is simple. These cables are “keyed” to only allow them

to be connected in the correct manner. TYAN motherboards have two on-board IDE

channels, each supporting two drives. The black connector designates the Primary

channel, while the white connector designates the Secondary channel.

Attaching IDE cables to the IDE connectors is illustrated below:

Simply plug in the BLUE END of the IDE cable into the motherboard IDE connector,

and the other end(s) into the drive(s). Each standard IDE cable has three connectors,

two of which are closer together. The BLUE connector that is furthest away from the

other two is the end that connects to the motherboard. The other two connectors are

used to connect to drives.

NOTE: Always remember to properly set the drive jumpers. If only using one device

on a channel, it must be set as Master for the BIOS to detect it.

TIP: Pin 1 on the IDE cable (usually designated by a colored wire) faces the

drive’s power connector.

Attaching Serial ATA Cables

The S5393 is also equipped with 6 Serial ATA (SATA) channels.

Connections for these drives are also very simple.

There is no need to set Master/Slave jumpers on SATA drives.

Tyan has supplied two SATA cables and one SATA power adapter. If you are in need

of other cables or power adapters please contact your place of purchase.

The following pictures illustrate how to connect an SATA drive

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Pas de commentaire

Tyan S5393WG2NR Fiche technique Page 25